Fanuc alarm: START REJECTED – START REJECTED

CNC Machine Alarm Error & Message: START REJECTED – START REJECTED
Fanuc Alarm Description:
Automatic operation start cannot be accepted due to one of the conditions below. 1) Automatic Operation Stop signal (*SP) is at low level. 2) An alarm state 3) SRN signal has been issued. 4) Program start was attempted while the same program was being edited. 5) PTR (or RS-232-C) is not in the ready state with the tape mode selected.

Additional Suggestions & Fanuc alarm: START REJECTED – START REJECTED Clarification:
None currently

Troubleshooting Recommendations for (Fanuc alarm: START REJECTED – START REJECTED) Error Message:
Any additional suggestions or recommendations on the Fanuc alarm: START REJECTED – START REJECTED message please post comments below.

Fanuc CNC Control Models Applicable:10/11/12


Fanuc alarm: START REJECTED – START REJECTED