Fanuc alarm: PS205 – TURRET REG. NOT FINISHED

CNC Machine Alarm Error & Message: PS205 – TURRET REG. NOT FINISHED
Fanuc Alarm Description:
Turret indexing is specified without performing the reference point return.

Additional Suggestions & Fanuc alarm: PS205 – TURRET REG. NOT FINISHED Clarification:
Send machine home as well as try indexing the turret with the manual buttons on the machine to home some turrets before programming them to run.

Troubleshooting Recommendations for (Fanuc alarm: PS205 – TURRET REG. NOT FINISHED) Error Message:
Any additional suggestions or recommendations on the Fanuc alarm: PS205 – TURRET REG. NOT FINISHED message please post comments below.

Fanuc CNC Control Models Applicable:10/11/12


Fanuc alarm: PS205 – TURRET REG. NOT FINISHED