Fanuc alarm: 5124 – CAN NOT COMMAND SPIRAL(M series)

CNC Machine Alarm Error & Message: 5124 – CAN NOT COMMAND SPIRAL(M series)
Fanuc Alarm Description:
A spiral interpolation or conical interpolation was specified in any of the
following modes:
1) Scaling
2) Programmable mirror image
3) Polar coordinate interpolation
In cutter compensation C mode, the center is set as the start point or
end point.

Additional Suggestions & Fanuc alarm: 5124 – CAN NOT COMMAND SPIRAL(M series) Clarification:
None currently

Troubleshooting Recommendations for (Fanuc alarm: 5124 – CAN NOT COMMAND SPIRAL(M series)) Error Message:

Fanuc CNC Control Models Applicable:16/18/21, 16i/18i/21i, 160i/180i/210i, ,


Fanuc alarm: 5124 – CAN NOT COMMAND SPIRAL(M series)